Can I remove a Jinko Solar module?

Do not remove any part installed by Jinko Solar or disassemble the module. All instructions should be read and understood before attempting to install, wire, operate, and maintain the module. Do not lift up PV modules using the attached cables or the junction box. All PV systems must be grounded to earth.

What temperature should a Jinko Solar PV module be installed in?

Limit working ambient temperature range: -40° C to + 70° C 2.2.2 Site Selection In most applications, Jinko solar PV modules should be installed in a location where they can receive maximum sunlight throughout the year.

Can JinkoSolar PV modules be installed near the seashore?

Operation in permanent shading conditions is not recommended. Do not install the PV module near open flame or flammable materials. JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test.The PV modules can be installed at a distance of 50m away from the seashore.

What pressure does a Jinko module meet?

er stickers match.Jinko modules are designed to meet a maximum positive (or downward) pressure of 3600Pa (Only refer to the mentioned module type in this manual) and negative (or upward) pressure of 1600Pa. This design load was then tested with a safety

What is the length of a Jinko module?

below in Figure 11. For Jinko standard full module L is 900/1200mm, the half–cut module L is 145/290mm, and the SWAN bifacial mo ule L is 150/250mm. For customized module, L can be base on your condition. Please take the cable length into consideration before designin

Do Jinko Solar PV modules pass the salt spray corrosion test?

JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test.The PV modules can be installed at a distance of 50m away from the seashore. In the case when the modules are installed within 50m to 500m distance from the seashore, the connectors shall be protected, i.e., adding dust plugs.