Does JinkoSolar have a vertically integrated solar product value chain?

JinkoSolar has built a vertically integrated solar product value chain, with an integrated annual capacity of 31 GW for mono wafers, 19 GW for solar cells, and 36 GW for solar modules, as of September 30, 2021.

Where should Jinko PV modules be installed?

Jinko PV modules should be installed in suitable locations. Do not install the mod-ules in places that could be flooded. Be careful when installing the photovoltaic modules particularly at the corners of the racks or trackers.

Do JinkoSolar PV modules pass the IEC 61701 salt spray corrosion test?

JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test. PV modules can be installed at a distance of 50m away from the seashore. In the case when the modules are installed within 50m to 500m distance from the seashore, the connectors shall be protected, i.e., adding dust plugs.

What pressure does a Jinko module meet?

er stickers match.Jinko modules are designed to meet a maximum positive (or downward) pressure of 3600Pa (Only refer to the mentioned module type in this manual) and negative (or upward) pressure of 1600Pa. This design load was then tested with a safety

What is the length of a Jinko module?

below in Figure 11. For Jinko standard full module L is 900/1200mm, the half–cut module L is 145/290mm, and the SWAN bifacial mo ule L is 150/250mm. For customized module, L can be base on your condition. Please take the cable length into consideration before designin

Can I drill a hole in a Jinko module?

Do not drill holes in the frame without authorization from Jinko, which may cause corrosion or other negative effects to the module. Thermal expansion and cold contraction effect occur on the modules. During installation, the interval between two adjacent modules must be ≥ 10mm.