How to connect solar water heater & solar flat plate collector?

The solar water heater and solar flat plate collector panel/s or manifold for the solar vacuum tubes must be connected by using 22mm copper piping, 22mm female Conex fittings and/or 22mm copper elbows and tee-pieces and thermal pipe lagging. Page 10 THEMOSYPHON SPLIT SYSTEM METHOD-DIRECT & INDIRECT SYSTEMS WITH SOLAR FLAT PLATE COLLECTOR PANEL/S 1.

How do I install a solar stack module?

Insert the end clamps laterally in the pedestal. The end clamps are attached and then tightened at the height of the module frame. Modules should be installed to the Solar Stack pedestals with the manufacturer approved middle/end clamps. There are different types of clamps available for the module installation.

How to install a solar water heater?

Install the pitch roof support with solar water heater cradle available from Kwikot at the marked position. Place the solar water heater into the cradle. 5. Important Installation Information In an Indirect system installation, the solar water heater must be fitted with an Expansion Relief Valve 100kPa on the left top side of the front end dome.

How do I install a solar array on a roof?

Using your engineered design, locate the array layout on the roof, and determine mount locations. Measure and determine the spacing between the Solar Stack pedestals according to the solar array design. Mark the lines across the roof for all the mounts.

How do I connect a solar stack module to a pedestal?

Modules should be bonded to the Solar Stack pedestals with the manufacturer approved middle/end clamps. Grounding hardware (as a part of the module clamps) forms secure electrical bonds with both the module and the pedestal, resulting in many parallel grounding paths throughout the system.

How do I install a solar stack roof?

Surface Preparation. All roof surfaces must be free of any debris, dirt, grease, oil, and standing water before adhesive is applied. Follow adhesive manufacturers application instructions. Tile roofs: Tiles must be cut to t the proper size of the Solar stack pedestal (+- 1''). Clean the hole of any sawdust with appropriate tools and materials.