How do I install a solar stack roof?

Surface Preparation. All roof surfaces must be free of any debris, dirt, grease, oil, and standing water before adhesive is applied. Follow adhesive manufacturers application instructions. Tile roofs: Tiles must be cut to t the proper size of the Solar stack pedestal (+- 1''). Clean the hole of any sawdust with appropriate tools and materials.

How do I install a solar array on a roof?

Using your engineered design, locate the array layout on the roof, and determine mount locations. Measure and determine the spacing between the Solar Stack pedestals according to the solar array design. Mark the lines across the roof for all the mounts.

Can solar stack be installed on a concrete roof?

Solar Stack pedestals can be installed on BUR (Build Up Roong), Mineral surface (Modied Bitumen), EPDM, PVC, TPO, Hypalon and Concrete roofs. Solar Stack's innovative design incorporates a patented pedestal used in conjunction with a code-approved adhesive.

How do I install a solar stack module?

Insert the end clamps laterally in the pedestal. The end clamps are attached and then tightened at the height of the module frame. Modules should be installed to the Solar Stack pedestals with the manufacturer approved middle/end clamps. There are different types of clamps available for the module installation.

How do I connect a solar stack module to a pedestal?

Modules should be bonded to the Solar Stack pedestals with the manufacturer approved middle/end clamps. Grounding hardware (as a part of the module clamps) forms secure electrical bonds with both the module and the pedestal, resulting in many parallel grounding paths throughout the system.

How do you put a solar stack pedestal in foam?

Solar Stack pedestal should be placed into foam within 1-2 minutes after foam is dispensed. All exposed polyurethane adhesive should be protected from UV exposure. This can be accomplished by coating with an exterior grade acrylic paint/coating or covering the foam adhesive with another method.